Discussion in 'OT Driven' started by gandhibrokemyskates, Jan 30, 2004.
putting SR20det motors in their 240's? It's not like they need them too make power.
That's not Nissan guys, it's 240sx bandwagoneers.
That's not nissan guys that's ricers
edit: I was too slow
same difference. carry on.
its like honda kids obsessed with swapping out to some b16 or b2whatever, i dont know their codes...
stock civic motors don't make much power, but the stock 240 motor can make 700 horsepower with rods and pistons, turbo kit, and engine management.
how much power can a stock 240sx bottom end handle?
btw, I'm just waiting for alphaintegra to make some stupid witty remark in here. that tool.
They don't... Only in America do they do that.
The rest of the world had SR20DETs standard.
But the SR20DET is JDM, y0!
I may look into one.
Anyone wann buy a 10 second CRX?
the rods and pistons are fairly weak stock, but if you replace those two. gawd damn, it makes a lot of power.
The sleeves are strong enough?
EDIT: what am I talking about. Only our Honda sleeves suck
Who cares? What really matters is that there are Maximas putting down 500whp with the stock bottom end.
but i'm not talking about maxima's, i'm talking fuckin 240's!
It's an iron block, there are no sleeves.
I care, I've been thinking about getting one for a while.
how do you know this?
KA motors don't have sleeves.
There's my next project
I was around Duy's 10.8 @ 132 KA powered 240sx. That's how I know.
How will the rest of the drivetrain hold up? Tranny/rearend etc.
Sorry I'm a Honda guy
Can someone recommend a good Nissan forum?
he spends too much money. anyone that spends that kind of money on any car will have a powerful engine...
I'm a honda guy too. The head will hold with that kind of power. pretty wicked. You'll need to get a rear diff. I'm not sure if the rear end will hold or not. Tranny will hold, sorta.