TAT Standard Industrial size?

Discussion in 'Vaginarium' started by Turboed_2, Jan 29, 2005.

  1. Turboed_2

    Turboed_2 .

    Joined:
    Oct 23, 2001
    Messages:
    25,477
    Likes Received:
    5
    I got my industrial done about a year ago and never replaced the jewelry. I wanted to swap out the single bar for 2 smaller ones so that it could heal properly and the scar tissue would go down, but I haven't found any that are small enough (1cm long about) so I decided to buy a single long barbell that was black. I got it online and unfortunately didn't read the size, it was 14 ga. I remember being pierced with a 12 ga.....so now I'm wondering a few things. Is the standard size 14 ga for industrials? and would anyone know where I could get small jewelry or a black 12 ga industrial bar? Thanks :x:
     
  2. Synner

    Synner New Member

    Joined:
    Jan 11, 2005
    Messages:
    2,461
    Likes Received:
    0
    14g is typically standard, but some people prefer to go bigger...but hell, might as well just put the 14g in. Cartilage piercings themselves don't heal, just the skin over them. So if you got a 12g bar later, all you'd have to do is stretch the skin, but inside the piercing would still fit.
     
  3. Turboed_2

    Turboed_2 .

    Joined:
    Oct 23, 2001
    Messages:
    25,477
    Likes Received:
    5
    Cool, thanks :big grin: I'll try it today.
     

Share This Page