GUN Ruger Mark III Disassembly/assembly Problems/jammed

Discussion in 'On Topic' started by RebootEnzo, Apr 11, 2008.

  1. RebootEnzo

    RebootEnzo New Member

    Joined:
    May 21, 2007
    Messages:
    841
    Likes Received:
    0
    Well guys I sold my MKIII to a friend of mine and I was saying to my friend that he needs to learn how to take it apart. So I say follow the manual Exactly how it says to do everything because it is kinda of bitch to learn but once you learn the dance for the MKIII its not that bad. Anyways he was not paying attention to were he was putting the last part in and he missed the hole that it should go through pushing it up into the bolt, the the incorrect place. Now it is caught between two parts and will not come out again. Any clues on how to get this part out?
     
  2. houseofdon

    houseofdon Simplify Moderator

    Joined:
    Sep 23, 2003
    Messages:
    4,931
    Likes Received:
    0
    Location:
    Michigan's West Coast
    I've done that before :o Honestly, if a good pull doesn't get it out, I'm not sure what his options are. Don't be afraid to muscle it.
     
  3. mvizos

    mvizos New Member

    Joined:
    Nov 12, 2003
    Messages:
    3,675
    Likes Received:
    0
    Location:
    NoVA
  4. RebootEnzo

    RebootEnzo New Member

    Joined:
    May 21, 2007
    Messages:
    841
    Likes Received:
    0

    Wont pulling too hard snap the part it is jammed on?
     
  5. Ford4Life

    Ford4Life Guest

    Get a rubber mallet and tap it downward, will come out.
     
  6. Y2kAccord

    Y2kAccord Everything happens for reasons I just dont know

    Joined:
    Jun 16, 2000
    Messages:
    56,089
    Likes Received:
    0
    Location:
    Texas Bound!
  7. RebootEnzo

    RebootEnzo New Member

    Joined:
    May 21, 2007
    Messages:
    841
    Likes Received:
    0
    We have been hitting it with the mallet but still is jammed.
     

Share This Page