forwarding ports with a D-link router??

Discussion in 'OT Technology' started by Achance007, Mar 15, 2004.

  1. Achance007

    Achance007 Active Member

    Joined:
    Oct 12, 2000
    Messages:
    16,128
    Likes Received:
    4
    Location:
    New Castle, DE
    [​IMG]
    What Ip's do I use for source and destination? I imagine for destination I use the Ip of my computer what do I use for source?[/
     
  2. Achance007

    Achance007 Active Member

    Joined:
    Oct 12, 2000
    Messages:
    16,128
    Likes Received:
    4
    Location:
    New Castle, DE
    found the answer, so never mind




    Step 1 Open your web browser and enter the IP address of your D-Link router (192.168.0.1). Enter username (admin) and your password (blank by default).

    Step 2 Click on the Advanced tab at the top and then click Firewall on the left side.

    Step 3 Click on Enabled and type in a name for the new rule.

    Step 4 Choose WAN as the Source and enter a range of IP addresses out on the internet that you would like this rule applied to. If you would like this rule to allow all internet users to be able to access these ports, then put an Asterisk in the first box and leave the second box empty.

    Step 5 Select LAN as the Destination and enter the IP address of the computer on your local network that you want to allow the incoming service to. This will not work with a range of IP addresses.

    Step 6 Enter the port or range of ports that are required to be open for the incoming service.

    Step 7 Select Always for the Schedule or specify a range of Day and time that you would like this rule to be active.
     

Share This Page