Configuring a Cisco Terminal Server

Discussion in 'OT Technology' started by Project X, Jun 29, 2005.

  1. Project X

    Project X New Member

    Joined:
    Nov 16, 2003
    Messages:
    967
    Likes Received:
    0
    I have a Cisco terminal server, a switch, 3 juniper networks routers. I have the ethernet connection to the management port and console port to each router already. The lab net is 172.25.44.0/24 and the gateway is 172.25.44.1.

    How do I intially configure the Cisco 2500 terminal server? How do I access it and put in the configurations and add the management/console IP addresses? We have other terminal servers in the lab and I can copy over those configurations. The show run command shows the configuration and config t allows changes to be made. But I do not know how to access the terminal server after it is powered on.

    Thanks
     
  2. Project X

    Project X New Member

    Joined:
    Nov 16, 2003
    Messages:
    967
    Likes Received:
    0

Share This Page