Can someone help me out with a diagram.

Discussion in 'OT Technology' started by Blair, Feb 16, 2004.

  1. Blair

    Blair New Member

    Joined:
    Mar 13, 2003
    Messages:
    8,532
    Likes Received:
    0
    Location:
    Oregon
    I am going to be installing two components with crossovers, two coxials (that is off a four channel) then i am going to bridge a two channel to run a single 10. Can someone show or tell me what i will need wiring wise. I figure i will need an amp kit with distribution block. What will i need for RCAs? Anywhere to get cheap wiring online? thanks for any help guys.
     
  2. Scott P

    Scott P I are lurking through. . .

    Joined:
    Nov 10, 2001
    Messages:
    434
    Likes Received:
    0
    Location:
    Atlanta
    you are going to need most likely a 4 gauge amp kit with a distribution block that allows for you to go from one 4 guage power wire to two 8 guage power wires (one for each amp) as forthe rca's it depends on the amps, and to a lesser degree the Head unit being used, but essentially you need 6 channels worth of rca's (3 pairs of rca's) you may be able to get away with other setups but i would need to know what amps and head unit you are using.
     

Share This Page