Can someone design a sub box (winISD or the like) for me?

Discussion in 'OT Technology' started by MaximaDrvr, Sep 21, 2009.

  1. MaximaDrvr

    MaximaDrvr Member

    Joined:
    Sep 29, 2006
    Messages:
    582
    Likes Received:
    0
    Location:
    Raleigh, NC
    RE XXX 15'' sub
    Electrical Q Value -Qes: 0.58
    Mechanical Q Value -Qms: 3.62
    Total Speaker Q Value -Qts: 0.501
    Free Air Resonance -Fs: 19.10 Hz
    Equivalent Compliance -Vas: 207.0 liters
    One-Way, Linear Excursion -Xmax: 54 mm
    Efficiency -SPL 1W/1m: 85.81 dB SPL
    Effective Piston Area -Sd: 810 cm^2
    DC Resistance -Re: 4.2 ohm
    Nominal Impedance -Znom: Dual 2 ohm
    Thermal Power Handling -Pe: 2000 W
    Force Factor -Bl: 18.16

    The amp is 1400W RMS.

    Trunk Depth: 35"
    Trunk Width: In between the tire wells.. 39"
    Trunk Height: Lowest point @ 21", highest 24"

    Outside trunk opening width: 37"
    Outside trunk opening height: 17" (slanted)
    I can fold the seats down and gain access to the trunk.Seats folded down opening: 37" Width x 18" Tall (not slanted)

    I'm looking for a ported box that sounds decent with the highest output possible given the space restrictions.

    Thanks for any help.
     
  2. MaximaDrvr

    MaximaDrvr Member

    Joined:
    Sep 29, 2006
    Messages:
    582
    Likes Received:
    0
    Location:
    Raleigh, NC
    anyone?
     
  3. JRock10

    JRock10 Active Member

    Joined:
    May 25, 2005
    Messages:
    7,751
    Likes Received:
    0
    Location:
    Nashville, TN FTW
    try caraudio.com, seriously. as a matter of fact, there will probably be a design for that already. just look around over there
     
  4. MaximaDrvr

    MaximaDrvr Member

    Joined:
    Sep 29, 2006
    Messages:
    582
    Likes Received:
    0
    Location:
    Raleigh, NC

Share This Page